+8615980012906 xdm.neo@gmail.com
News
Home > News >

The Hammer Head Of The Hammer Crusher Machienry Equipment Is

When it was put into production this time, the hammer head of the hammer crusher was not worn on the surface and corners. The hammer head mainly bears the impact force. Then, the material hits the surface of the hammer head with a positive force, deforming the hammer head and hits, but if the hammer head wears out, the hammer head will exert an impact force on the hammer head due to the force-bearing surface on the surface. , The tangential force will exert a cutting force on the hammer head. Directly reduce the impact force of the hammer crusher when crushing materials, reduce production efficiency and increase crushing time. Therefore, when the force of the hammer head of the hammer crusher changes and the wear of the hammer head changes, it indicates that the life of the hammer head is about to end and the hammer head will fail.

 

  The main internal structure of the hammer crusher: the rotor of the hammer crusher consists of a main shaft, a rotor disc and a double alloy composite hammer head. The working principle of the hammer crusher: the motor drives the rotor to rotate at high speed in the crushing cavity. The hammer head is the main wear part, and the efficiency of the rotor disc directly affects the crushing of the crusher. The weight and peripheral speed of the hammer crusher rotor are very heavy, so the maintenance of the system and the number of hammer heads require the rotor to maintain a greater level of damage.


How to replace the hammerhead parts: When the hammerhead is worn or torn, you need to replace the hammerhead or turn it over. Replace the weight of the hammer with a standard hammer. Some regulations should replace the worn 50mm, but most people will work according to the actual work. Condition, check the hammer and replace small parts when not hitting the production material or putting down the crusher. Attention should be paid to replacing the hammer of the new member to arrange a new balance. The weight of the hammer head can be divided into three types: heavy, heavy and light. Fast parts weld a 40 mm * 40 mm steel plate with a thickness of 4 mm, and then hammer at each position. It should be noted that the direction of the hammer crusher can not limit the flow of the dead zone of the hammer, which is basically the sprint performance of the inner arc hammer at two points. In this way, the hammer is not sticky, and the cushioning is reduced during the tangent to the hammer plate, which reduces the impact and saves losses.

         

  The hammer crusher is used to crush various medium-hard and weak abrasives. The compressive strength of the material does not exceed 100MPa, and the moisture content is less than 15%. The crushed materials are coal, salt, chalk, gypsum, brick, limestone, etc. It is also used to crush the fiber structure, elasticity and waste of asbestos cement to recycle asbestos fibers.

            

  Unique advantages of hammer crusher:

          

  1. Easy to operate: The structure design is very mature and reasonable, with a small footprint, light weight, easy operation and maintenance.

          

  2. The quality is more reliable: the vulnerable parts such as the hammer are made of domestic excellent materials, which have good wear resistance, toughness and firmness, and the service life is greatly extended.

          

  3. High output: Due to the unique structure design of the equipment, the equipment has a large ore processing capacity and high output.

          

  4. High crushing efficiency: Compared with the same type of hammer crusher in China, the crushing efficiency of this equipment is increased by more than 40%, and it is currently the most efficient ore crushing equipment on the market. 5. Low production cost: during the operation of the equipment, the energy consumption is very low, the power consumption is very low, the failure rate is low, and the total production cost is relatively small, which can save the investment cost of the processing plant by nearly 70,000 yuan per year.